Transmitter Unit
• Using a flat screwdriver, insert into the small slot at the base of the unit to facilitate this.
Remove the circuit board (it may be secured with a small screw). Insert the supplied CR2032
into the battery holder, ensuring polarity of battery on installation (positive facing outwards).
Reinsert the circuit board with screw in place.
• Close the Transmitter enclosure by setting the fastening tab of the top cover into the slot
on the base. Then carefully press the top cover onto the base. It should click neatly into place,
ensuring the waterproof rating of the Transmitter.
What is Auto-learning Code?
The Transmitter sends a wireless signal to the Receiver. The Receiver would automatically register and
memorize the signal as an operation code. So the Transmitter can work with the Receiver by this code.
Auto-learning Code Set Up
1. Operation for 1 Transmitter and 1 Receiver
• (A) After battery installation on both Transmitter and Receiver, press the Transmitter once to generate
a new operation code. The Receiver will sound, which indicates that a new operation code is registered
and memorized.
• (B) Alternatively, press the auto-learning code button on the back of the Receiver once and it will be
ready to receive signal sent from the Transmitter. Press the button of the Transmitter, the Receiver will
sound to indicate that new operation code is registered and memorized.
Expanding your system or up to 4 Receivers to a single Transmitter
• You can pair up to 4 Receivers to a single Transmitter, by repeating Step B above for each Transmitter
(one at a time).
• Please note these items are only sold in New Zealand/Australia as a complete kit of both Transmitter
and Receiver together. These are not available for purchase as individual items.
• Paring multiple Transmitters to a single Receiver, the Transmitter will ring the same melody only.
• Paring multiple Receivers to a single Transmitter, select different melodies is allowable when pairing.
NOTE: Interference from another similar door chime operating nearby
(For example, Receiver sounds for no reason):
• Remove the batteries from the Receiver and rest for 60 seconds. This will erase the memory.
Insert the batteries again, and then the Transmitter and the Receiver are ready for the new code
registration. Repeat Step B above to re-pair.
• It is important to remember that when you replace the run-out batteries with new ones that you
will need to follow the same procedure of the auto-learning code set-up as above.
SETUP THE AUTO-LEARNING CODE
3
