Cancelling programming
9
Re-adjustement of end limits
8
9.1
- Switch off the 12V power supply to the motor for 2 seconds.
- Switch on the 12V power supply to the motor for 7 seconds.
- Switch off the 12V power supply to the motor for 2 seconds.
- Switch the power to the motor back on.
The motor will run for 5 seconds in random direction and is now in the
cancelling mode.
9.2
- Then, validate the cancelling of the affected motor from the individual control or from a new transmitter
1- Position the motor on the UP end limit previously set in §3.2 with the UP key.
2- Press simultaneously for 5 seconds the UP and DOWN keys, the motor will run for 0.5 second in one direction and then
in the other direction.
3- Adjust the new position with the UP and DOWN keys.
4- Validate the new position by pressing 2 seconds the STOP key. The motor will run for 0.5 second in one direction and
then in the other direction. The new end limits setting is memorized.
1- Position the motor on the DOWN end limit previously set in §3.2 with the DOWN key.
2- Press simultaneously for 5 secondes the UP and DOWN keys, the motor will run for 0.5 second in one direction and
then in the other direction.
3- Adjust the new position with the UP and DOWN keys.
4- Validate the new position by pressing 2 seconds the STOP key. The motor will run for 0.5 second in one direction and
then in the other direction. The new end limits setting is memorized.
8.1 - Re-adjustement of UP end limit:
8.2 - Re-adjustement of DOWN end limit:
- Press the “PROG” key of the transmitter more than 7 seconds. Maintain
the pressure until the motor will first run for 0,5 second in one direction
and then the other, and a few second later, it will run again in both
direction.
The motor is now as it was originally configured
, and no transmitter
and no settings is saved in its memory and is ready for a new programming
(§3).
4/4
5s
2s
1
2
3
4
5s
2s
1
2
3
4
