• Fill kettle between the minimum and maximum levels shown on the water level window.
• Note: Do not attempt to fill while the kettle is on the power base.
Do not use for other than boiling water. Other liquids will contaminate the interior of the kettle.
Do not fill past the MAX level indicated on the water level window. Overfilling may cause water to
spill out when boiling.
• Place kettle on the base making sure it is correctly engaged on its base.
• Depress the On/Off Switch to the ‘On’ position. The indicator light will illuminate to indicate that
the kettle is in the boil cycle. Once the water has boiled, the On/Off Switch will automatically switch
to the ‘Off’ position and the indicator light will go out.
• If you want to use the kettle again, allow the thermal safety switch to cool down for 15
– 20 seconds then depress the On/Off Switch to the On position. If the On/Off Switch does not
remain in the ‘On’ position, the water is hot enough to use without reheating.
• Unplug cord from wall outlet before lifting kettle from power base. Grip the kettle by the Handle
only, as the surface and lid will be hot.
• Return the kettle to the power base or place on a heat resistant surface after use.
• If the kettle is accidently switched on when empty, the thermostat will automatically shut it off to
prevent the kettle from overheating. If this situation occurs, unplug the power base and let the kettle
cool before refilling.
• It is recommended that the power cord be disconnected from the wall outlet when not in use. Do
not attempt to connect any other appliance to the power base or tamper with the connector in any
way.
CLEANING AND MAINTENANCE
• Unplug power cord from wall outlet. Empty out remaining water and allow kettle to cool before
cleaning.
• If necessary, remove and clean the Aquascreen filter (R) by rinsing under running water. The filter
can be removed by grasping firmly between your thumb and forefinger and gently pull off starting at
either the right or left edge.
• Under normal use, a deposit of scale may form on the inside of the kettle and cause some
discolouration. Scale, which has accumulated inside the kettle, can be removed
CLEANING AND MAINTENANCE
by boiling equal parts of white vinegar and water (500 ml / 2 cups of each is recommended). Once
the water has boiled, allow mixture to stand several hours or overnight. Empty out mixture and fill
kettle to the MAX level with fresh water. Bring water to a boil and discard. For heavy scale build-up,
repeat this process.
Note: This build-up can be delayed by pouring out old water and refilling before each use.
• Do not use abrasive cleaners
• Do not immerse kettle or power base in water or other liquid.
CAUTION
A short supply cord is provided to reduce the hazards of becoming entangled in or tripping over a
long cord. Extension cords may be used if care is exercised in their use. If an extension cord is used,
the marked electrical rating of the detachable power-supply cord or extension cord should be at least
as great as the electrical rating of the appliance. If the appliance is of the grounded type, the
extension cord should be of a grounded 3- wire cord. The extension cord should be arranged so that
it will not drape over the counter top or table top, where it can be pulled on by children or tripped
over.
