Simrad SC90, Installation Manual

Page: 506 / 544

504
419050/B
6 Once the carton is open, carefully remove all loose packing and insulation material.
7 Check for user manuals and other documents that may have been added to the
carton during packing.
8 Check also for special tools, door keys etc.
Related topics
Unpacking mechanical units, page 504
Unpacking electronic and electromechanical units, page 505
Unpacking mechanical units
Prior to installation or use, mechanical units must be unpacked from their transport boxes.
It is important that this unpacking is done without inflicting damage to the equipment.
Prerequisites
Observe the procedure for unpacking of standard parts and units.
Context
Mechanical and electromechanical units may be heavy.
Hull units provided for sonar systems are provided with the transducer already mounted.
Note
The transducer is a delicate item. Make sure that it is not exposed to physical damage
during the storage, unpacking, lifting and installation of the hull unit. The transducer is
protected with a box shaped foam. Do not remove this protection until the final stages of
the hull unit installation.
A transducer must always be handled as a delicate item. Wrongful actions may damage
the transducer beyond repair.
Observe these transducer handling rules:
•
Do not
activate the transducer when it is out of the water.
• Do not handle the transducer roughly, avoid impacts.
• Do not expose the transducer to direct sunlight or excessive heat.
•
Do not
use high pressure water, sand blasting, metal tools or strong solvents to clean
the transducer face.
• Do not damage the outer protective skin on the transducer.
Procedure
1 Obtain the necessary lifting equipment, and make sure that the equipment is
certified for the weight.
2 Lift the unit out of the transportation box.
Simrad SC90 Installation Manual