WIRING: Wiring diagram
14
9
15
16
Switch the autopilot to Power Steer mode.
Press and hold the arrow keys on the Autopilot controller in steps less
than 3 seconds at a time, until the cylinder reaches max travel in both
directions. The screenshots above are examples from HDS and NSS
evo2.
Continue to run the pump in both directions until no air bubbles are
left in the transparent tube.
IMPORTANT: Check fluid level
MOUNTING: Bleeding the hand steering
Turn the wheel until the cylinder reaches max travel in both directions,
and refill oil.
Keep turning and refilling oil until the oil level is stable and the
outboard engine responds firmly.
If air bubbles still remain in the system, follow the bleeding procedure
described for the outboard cylinder.
¼
Note:
It is recommended to use a threaded filler tube if available.
MOUNTING: Bleeding Pump-1
CORRECT
FLUID LEVEL
12
MOUNTING: Identify Type of Fitting Required
POR
T
STB
STB
POR
T
IMPORTANT: TRANSPARENT HOSE
+
_
12 V DC
MAIN
POWER
SWITCH
0.9 m (3 ft)
FUSE,
20 AMP
2 m (6 ft)
1 m (3 ft)
2 m
(3 ft)
5 m
(15 ft)
0.6 m
(2 ft)
1.8 m (6 ft)
T
T
3 AMP
AUTO/STBY
BUTTON
POINT
-1AP 1.2 m (4 f
t)
Precision-9
4.5 mm (15 ft)
POINT-1AP
RED
BLACK
YELLOW
BLUE
Precision-9
ECHO
VIDEO IN
NMEA 2K
NETWORK
POWER
ECHO
VIDEO IN
NMEA 2K
NETWORK
POWER
POR
T
13
MOUNTING: Pump-1, Connect hoses
IMPORTANT: TRANSPARENT HOSE
Configuration
Compliance Statements
Refer to your Autopilot controller’s documentation for setup
instructions.
The Outboard and the DrivePilot:
•
Comply with CE under EMC directive 2004/108/EC
•
Comply with the requirements of level 2 devices of the
Radiocommunications (Electromagnetic Compatibility) standard
17
11
MOUNTING: Disconnecting the hoses from helm
pump
1
2
3
STB
POR
T
10
Installing with optional Verado fitting kit for
Pump-1
310 mm
930 mm
VERADO STEERING
CYLINDER VOLUME
APPROX. 9ci - 150 cc
VERADO ELECTRO
HYDRAULIC POWER PACK
VERADO HELM
HIGH PRESSURE
STEERING LINES
LOW PRESSURE
RETURN LINE
HIGH PRESSURE
SUPPLY LINE
RETURN LINE
EXTENSION
HIGH PRESSURE
SUPPLY LINE
HIGH PRESSURE
STEERING LINES
STEERING LINES
RETURN LINE
LOW PRESSURE
RETURN LINE
STEERING LINE
EXTENSION
STB
ORB Fittings
NPT Fittings
DO NOT USE NPT FITTINGS
The drawing shows a SeaStar helm pump which identifies fittings using
text engraved on the back.
¼
Note
:
Helm and fittings required may vary by manufacturer.
¼
Note:
ORB and NPT fitting kits are supplied in separate bags. Discard
the fittings not used.
¼
Note:
Pay attention to the ports on the helm pump to ensure you are
using the correct fittings.
MOUNTING: Connect hoses to helm pump
Check all fittings for leaks.
Shop for other marine electronics & navigation on our website.