Simrad NSS12, Technical Manual

Page: 15 / 68

| 13
Mounting the NSS display | NSS Installation Manual
Mounting the NSS display
Panel mount
3
Attach the flush mounting template
to the selected mounting position
using adhesive tape.
Drill pilot holes for the four hole saw
cuts and four self tapping screws
used to secure the display. If using
M4 machine screws use a 5 mm
(0.20 ”) drill bit.
Peel backing off the gasket and ap-
ply to the surface.
Connect all cables to the rear of the
unit before placing the unit into the
console.
Secure the display to the surface.
To finish off the installation, firmly
clip the upper and lower bezels in
place.
Note: For flush installations the sup-
plied rear bezel (NSS7/8) is not used.
Use a 25 mm (1 “) hole saw to cut the
four corner radius.
Cut along the dotted line and
remove the shaded area.