Ú
Note:
Jackplate mount requires the separately sold
'StructureScan 3D, StructureScan HD & TotalScan Skimmer
Transom mount kit' (part no. 000-12603-001).
The transducer transom bracket can be mounted inside or outside
of the jackplate by drilling through the jackplate and then running
bolts through the hinge hole in the side of the bracket into the
jackplate. The illustration above shows the transom bracket
mounted inside the jackplate.
Ú
Note:
Sonar does not track bottom when the transducer is out
of the water.
Jackplate mount supplies (not included)
6 mm (1/4”) Drill bit (Jackplate
Mount)
M6 (1/4”) jackplate mount bolts
Warning:
Before installing the transducer on the
jackplate, lower the jackplate to its lowest setting to
make sure there is enough clearance between the
jackplate, engine, transom, and the transducer. Lack of
clearance could damage the transducer when the
engine is all the way down.
To mount transducer on jackplate using transom bracket
1.
Choose a transducer location on the inside or outside of the
jackplate.
2.
Adjust the jackplate up and down to make sure the transducer
will not obstruct jackplate movement.
3.
Make sure nothing blocks the sonar beam on either side of the
transducer.
4.
Route the transducer cable to the location where the display
will be installed.
5.
Move the transducer bracket into the desired position and use a
pencil to mark the holes through the hinge hole and hole in the
side of the bracket.
6.
Using a 6mm or equivalent drill bit, drill the holes into the
jackplate.
7.
Slide the bracket inside the jackplate and align the bracket holes
with holes you drilled in the jackplate.
Installation
| TotalScan Transducer User Manual
13