Simrad Halo20, Installation Manual

Page: 14 / 32

14 |
Installation | Halo20, 20+ and 24 Dome Radars Installation Manual
Scanner connection
¼ Note:
If replacing an existing Broadband 3G/4G Radar, refer to ”Replacing a Broadband 3G/4G
Radar” on page 22.
The scanner interconnection cable connects to the scanner using an 8 pin connector.
1.
Insert interconnection cable connector into the socket on the scanner, rotating locking collar
clockwise until it clicks.
2.
Place the cable into the cable retention channel.
3.
Install the two cable retainers (
A
) using the supplied screws. Tighten the screws gently.
¼ Note:
If routing the interconnection cable down through a hole in the mounting surface
concealed by the radar, install only the retainer nearest the interconnection cable socket.
¼
Note:
If installing the scanner in a location where the dome radar cannot be placed upside
down within the reach of the scanner cable, install the retainers on one side first. After the
cable is laid into place swivel the retainers (
B
) over the retention channel and gently tighten
the screws.
!
Warnings:
The retainers only help hold the cable in place. The retainers are not intended to provide
strain relief.
Do not allow the cable to be pulled tight when fitted to the scanner.
Do not hang the scanner from the cable.
A
B
Scanner connection details
1
3
2
7
5
6
4
8
1
3
2
7
5
6
4
8
Scanner socket Interconnection cable plug (scanner end)
Pin-out Wire color Description
1
Black DC negative
2
Yellow Power control
3
Green Data Receive -
4
White / Green Data R