2
5
To OPEN the Umbrella Light:
Open the umbrella light by holding firmly with one hand and then depress the clamp
release button with the other hand to release the clamp lock (Fig. 1).
To CHARGE/RECHARGE the Umbrella Light:
With the umbrella light opened, slide back the battery release button to remove the
battery pack from its compartment (Fig. 2). After removing the battery pack, plug the
charger into the battery input (Fig. 3), then plug charger into 110V electrical outlet for
6 hours to fully charge. After battery charging is complete, gently slide battery pack
back into compartment until battery pack snaps into place.
NOTE:
Only use the
supplied battery charger, charging the light with a substitute charger may damage the
battery pack or cause overheating, which could result in personal injury and/or other
damages.
To TURN ON and TURN OFF the Umbrella Light:
Depress the On/Off button to turn on and turn off LED lights.
Additional Features
S T E P 1
Assembly
No assembly is required for the umbrella light however, you must fully charge the
battery prior to first use.
Battery Compartment
On/Off Button
Battery Pack
Battery
Release Button
Clamp Release
Button
Charger Input
Battery Pack
(Fig. 1)
(Fig. 2)
(Fig. 3)
To ATTACH Umbrella Light to Cantilever Umbrella:
Loosen the light adapter built into the umbrella runner by turning counter-clockwise
(Fig. 7). After loosening, pull down light adapter post (Fig. 8) to attach the
umbrella light (sold separately).
To OPEN and ATTACH Umbrella Light:
Open the umbrella light by holding firmly with one hand and then depress the clamp
release button with the other hand to release the clamp lock. Open up the light and
clasp around the light adapter post (Fig. 9). Snap to close (Fig. 10).
To REMOVEand CLOSElight adapter:
Hold the umbrella light, depress the clamp release button to release the clamp lock.
Remove umbrella light, and gently push up the light adapter post back into umbrella
runner and tighten turning clockwise (Fig. 7).
(Fig. 7)
(Fig. 8)
(Fig. 9)
(Fig. 10)
