SimpliSafe CO Detector v3-0 Owners Manual (Revision UK1) — April 2021
1
Carbon Monoxide Detector Manual (SSCO3-0)
This carbon monoxide alarm is designed to detect carbon
monoxide from ANY source of combustion. It is NOT designed to
detect smoke, fire, or any other gas.
WARNING:
Carbon monoxide alarms are not smoke alarms. This
carbon monoxide alarm is not a substitute for installing and
maintaining an appropriate number of smoke alarms in your
home.
This CO alarm will not sense smoke, fire, or any poisonous gas
other than carbon monoxide even though carbon monoxide can
be generated by fire. For this reason you must install smoke
alarms to provide early warning of fire and to protect you and
your family from fire and its related hazards.
This appliance is not to be used, cleaned, or maintained by
persons (including children over 8) with reduced physical,
sensory or mental capabilities, or lack of experience and
knowledge, unless they are under supervision or have been
given instruction regarding safe use and understand the
hazards involved.
Children must not play with this appliance.
WARNING:
This product is intended for use in ordinary
indoor locations of family living units. It is not designed to
measure compliance with Occupational Safety and Health
Administration (OSHA), commercial, or industrial standards. It
is not suitable for installation in hazardous locations as defined
in the National Electric Code.
The installation of this device should not be used as a
substitute for proper installation, use and maintenance of
fuel burning appliances, including appropriate ventilation and
exhaust systems. It does not prevent CO from occurring, nor
can it solve an existing CO problem.
WARNING:
This device is designed to protect individuals from
acute effects of carbon monoxide exposure. It may not fully
safeguard individuals with specific medical conditions. If in
doubt, consult a medical practitioner. Individuals with medical
problems may consider using warning devices which provide
audible and visual signals for carbon monoxide concentrations
under 30 PPM.
This carbon monoxide alarm requires a continuous supply of
electrical power - it will not work without power.
This alarm has not been investigated for carbon monoxide
detection below 70 PPM.
CAUTION:
This alarm will only indicate the presence of
carbon monoxide at the sensor. Carbon monoxide may
be present in other areas.
For any questions regarding your CO Detector, please
contact:
SimpliSafe, Inc
294 Washington St Floor 9
Boston MA 02108
Email:
Website:
www.simplisafe.com
Phone:
1-888-957-4675
WARNING!!
Actuation of your CO alarm indicates the
presence of carbon monoxide (CO) which can KILL YOU.
If alarm signal sounds:
1.
Press the mute button
2.
Call your emergency services (fire department or 911)
3.
Immediately move to fresh air – outdoors or by an open
door/window. Do a head count to check that all persons
are accounted for. Do not reenter the premises nor move
away from the open door/window until the emergency
services responders have arrived, the premises have
been aired out, and your alarm remains in its normal
condition.
4.
After following steps 1 – 3, if your alarm reactivates
within a 24 hour period, repeat steps 1 – 3 and call a
qualified appliance technician to investigate for sources
of CO from fuel burning equipment and appliances,
and inspect for proper operation of this equipment. If
problems are identified during this inspection have the
equipment serviced immediately. Note any combustion
equipment not inspected by the technician and
consult the manufacturers’ instructions, or contact the
manufacturers directly, for more information about CO
safety and this equipment. Make sure that motor vehicles
are not, and have not been, operating in an attached
garage or adjacent to the residence.
Important Warning Statements
What to do in the event of a CO alarm
Customer Support