5
SimpliFire • SF-SCT43-BK, SF-SCT55-BK Service Manual • 2043-960 • 7/20
Flame Screen Replacement
1. Remove glass, see Glass Front and Glass Side
Panel Remove/Replacement instructions.
2. Access internal components, see Accessing Internal
Components instructions.
3. Remove the (3) screws in the top Flame Screen and
retaining bracket. Then remove the screws in the
bottom left and right corners of the Flame Screen
and retainer. Remove the Flame Screen. See Figure
14.
4. Install the replacement Flame Screen panel, smooth
(non-silk screened) side facing out by inserting the
flame screen in the channel, and re-attach brackets
and screws. See Figures 14 and 15.
5. Re-install components removed to access internal
components, see Accessing Internal components
instructions.
6. Re-Install glass per Glass Front Replacement.
Figure 14 Flame Screen
Figure 15 Glass Retainer/Ember Bed Bracket
Rotisserie Assembly and Rotisserie Motor
Replacement (Continued)
5. Remove motor bracket by removing three screws.
See Figure 17.
6. Remove two screws and two nuts that attach each
motor to the motor brackets. See Figure 18.
7. Disengage rotisserie rods from motors located in left
side of cavity. Use hand to shift the rotisserie rod
to the right until the rubber coupler on the left end
disengages from the motor shaft and lift out of the
appliance. See Figure 17.
If not replacing motors skip to step 13.
8. Remove each motor until the electrical connector is
visible. See Figure 18 and 19.
9. Disconnect the electrical connector to the motor. See
Figure 18 and 19.
10. Fasten the new motor to the motor bracket, with the
two screws and two nuts
11. Connect the new motor to the electrical connectors.
12. Re-install the motor and bracket with three screws.
See Figure 17.
13. Install the replacement (or existing) rotisserie rod.
Align the
rubber coupler with the motor shaft. Shift the rod to
the left until the rubber coupler fully engages the
motor shaft or on the left side. See Figure 17.
Replace the two screws for the rotisserie center
support. See Figure 16.
14. Re-install components removed to access internal
components, see Accessing Internal components
instruction.
15. Re-Install glass per Glass Front Replacement.
Figure 16 Rotisserie Center Support
CENTER SUPPORT
CENTER SUPPORT
Rotisserie Assembly and Rotisserie Motor
Replacement
1. Remove glass, see Glass Front and Glass Side
Panel replacement instructions.
2. Access internal components, see Accessing Internal
Components instructions.
3. Remove the Flame Screen, see Flame Screen
Replacement instruction. Only remove Flame
Screen if replacing back Rotisserie.
4. Remove two screws from the rotisserie center
supports. See Figure 16.
