13
Operating the Tractor
ATTACHING A TRAILER
NOTE: Remove the hopper to attach a trailer.
The maximum horizontal drawbar force allowed is 444
Newton. The maximum vertical drawbar force is 222
Newton. This equates to a 396 lbs (180 kg) trailer on a
10 degree hill. Secure the trailer with an appropriately
sized clevis pin (A, Figure 8) and clip (B).
(180kg)
396 Lbs
.
10˚
3'4"
(1m)
20' (6m)
Figure 8. Trailer Weight Recommendations
A. Clevis Pin
B. Clip
STORAGE
Before you store your unit for the off-season, read the
Maintenance and Storage instructions in the Safety
Rules section, then perform the following steps:
• Disengage the PTO, set the parking brake, & remove
the key.
• Perform engine maintenance and storage measures
listed in the engine owner’s manual. This includes
draining the fuel system, or adding stabilizer to the
fuel (do not store a fueled unit in an enclosed struc-
ture - see above).
• Battery life will be increased if it is removed, put in a
cool, dry place and fully charged about once a month.
If the battery is left in the unit, disconnect the nega-
tive cable.
Before starting the unit after it has been stored:
• Check all fluid levels. Check all maintenance items.
• Perform all recommended check and procedures
found in the engine owner’s manual.
• Allow the engine to warm up for several minutes
before use.
WARNING
Never store the unit (with fuel) in an enclosed,
poorly ventilated structure. Fuel vapors can
travel to an ignition source (such as a furnace,
water heater, etc.) and cause an explosion.
Fuel vapor is also toxic to humans and animals.
Figure 7. Deflector Plate
A Back Plate
B. Clevis Pins & Hair Pin Clips
A
B
A
B
5. Reinstall the mower deck.
6. Install the back plate (A, Figure 7) and secure with
clevis pins and hair pin clips (B).
