38
www.simplicitymfg.com
Figure 43. 2 x 4 Locations
A. 1/4” Spacers
Figure 44. Hanger Chain Adjustment
Deck Leveling Adjustment
NOTE: Before adjusting the deck level, the deck lift rod
timing must be checked and/or adjusted.
1. Park machine on a flat, level surface. Disengage the
PTO, stop the engine and engage the parking brake.
Rear tires must be inflated to 15 psi (1,03 bar); front
tires to 25 psi (1,72 bar).
2. Lock the deck lift pedal in the 5” (12,7cm) position.
Place the deck height adjustment pin in the 4” position
and lower deck the lift pedal until the arm contacts the
pin.
3. Place 2 x 4 blocks under each corner of the mower
deck with the 3-1/2” sides being vertical. Place a 1/4”
(0,64cm) thick spacer on top of the rear 2 x 4 blocks.
See Figure 43.
6. Adjust the front eyebolts until the chains are tight and
the deck is still resting on the 2 x 4’s and spacers.
Tighten jam nuts. See Figure 44.
7. Loosen the nuts and allow the rear of the deck to rest on
the 2 x 4’s and 1/4” spacers. Slide the chains down in
the slots until the chains are tight and tighten the nuts.
See Figure 44.
8. Remove all 2 x 4 blocks and spacers from under the
mower deck.
Figure 45. Deck Lift Spring Location
A. Deck Lift Spring
A
Deck Lift Spring
The deck lift springs (
A, Figure 45
) are factory set to
provide optimal lifting performance.
Although it is fastened with a multi-position anchor, this is
NOT an adjustment point.
Do NOT attempt to adjust the spring length or lifting
performance will be compromised.
Adjust
Here
Adjust
Here
A
Regular Maintenance
Summary of Contents for 5101604
Page 47: ......
