Instruction Manual
www.tksimplex.com
Hydraulic Cable Cutter – HCCS2375
www.tksimplex.com
4
4.
MAINTENANCE
1.
After use, the tool should be cleaned. Lubricate the area where the blade comes into contact with the head.
2.
Ensure all fasteners are securely fastened.
3.
In the event of oil leaks or improper functioning, contact your nearest SIMPLEX authorized service center for inspection
and repair.
CHANGING THE BLADE
Note:
Refer to Section 6 of this manual for parts list and item numbers. To help prevent damage to the tool, always
perform blade replacement procedures in a clean and dry work area.
To prevent possible serious injury, always relieve hydraulic pressure (0 psi/bar) and disconnect hydraulic hose
from tool before beginning blade replacement procedures.
The blade retaining screw (15) can be accessed with the blade in its standby position. Remove the screw (15) and remove
the old blade. Mount a new blade and check that the orientation is correct (see diagram, below). Apply Loctite 242 thread
sealant to threads of screw (15). Reinstall the screw (15) and tighten it to a torque of 531-620 in-lb [720-841 Nm].
5.
ADDITIONAL INFORMATION
All information, illustrations and specifications in this operation manual are based on the latest information available at the time of
publication. The right is reserved to make changes at any time without notice.
Equipment operators and installers shall be responsible for ensuring that a safe working environment and safe systems of work are
in place before operating the equipment.
Simplex declares that this product has been tested and conforms to applicable standards and complies with all CE requirements.
OK
OK