Instruction Manual
www.tksimplex.com
Hydraulic Cable Cutter – HCCP1500
www.tksimplex.com
4
3.
OPERATION
1.
Using the stationary handle, hold the tool in the upright position (cutting head facing up).
2.
Move the blade forward by pumping the integrated pump handle. Continue pumping until the blade reaches the end of its
stroke.
3.
Press the release button and check that the blade returns to its initial position.
4.
Remove the retaining pin (attached to chain) and open the cutting head.
5.
Place the material to be cut inside the cutting head. Then, close the cutting head and secure it with the retaining pin. Make
sure the retaining pin is fully installed.
6.
Pump the integrated pump handle to advance the blade. Continue until the material is fully cut.
7.
After cutting is completed, press the release button to move the blade back. Open the cutting head and remove all traces of
material before making another cut.
4.
MAINTENANCE
1.
After use, the tool should be cleaned. Lubricate the area where the blade comes into contact with the head.
2.
Ensure all fasteners are securely fastened.
3.
In the event of oil leaks or improper functioning, contact your nearest SIMPLEX authorized service center for inspection
and repair.
CHANGING THE BLADE
Note:
Refer to Section 6 of this manual for parts list and item numbers.
To help prevent damage to the tool, always
perform blade replacement procedures in a clean and dry work area.
Blade retaining screw (22) can be accessed with the blade in its standby position. Remove the screw (22) and remove the
old blade. Mount a new blade and check that the orientation is correct (see diagram, below). Apply Loctite 242 thread
sealant to threads of screw (22). Reinstall the screw (22) and tighten it to a torque of 531-620 in-lb [720-841 Nm].
5.
ADDITIONAL INFORMATION
All information, illustrations and specifications in this operation manual are based on the latest information available at the time of
publication. The right is reserved to make changes at any time without notice.
Equipment operators and installers shall be responsible for ensuring that a safe working environment and safe systems of work are
in place before operating the equipment.
Simplex declares that this product has been tested and conforms to applicable standards and complies with all CE requirements.
OK
OK
Summary of Contents for HCCP1500
Page 8: ......
