Document: LT0400
4100U-S1 Programming Guide
Addressable Device Settings
Issue 1.4
15 December 2010
Page 6-3
6.2.4
4098-9754E Multi-Sensor Photo Heat Detector (COMBO)
Mx-x-0 Parent Point
Device Type
COMBO
– Standard Multi-Sensor detector on standard base
ICOMBO
– Standard Multi-Sensor detector on Isolator base
SCOMBO
– Standard Multi-Sensor detector on Sounder base
Mx-x-1 1
st
Sub Point
Device Type
MPHOTO
– Standard setting
Point Type
– Photo Part
SMOKE
– Standard setting
VSMOKE
– Verified Smoke Detector (Recommended setting to reduce nuisance
alarms)
DUCT
– Duct detector
Mx-x-2 2
nd
Sub Point
Device Type
MHEAT
– Standard setting
Point Type
– Heat Part
MHEAT
– Standard setting
MOHEAT
– Standard heat detector with Rate of Rise
Mx-x-3 3
rd
Sub Point
Device Type
MARCOR
– Default not used in Australia
CAUTION DO NOT USE MARCOR SETTING NOT CSIRO ACTIVFIRE LISTED
Point Type
– R-Correlation Part
FCOR
– Alarm Smoke / Heat Correlation
UCOR
– Utility Smoke / Heat Correlation used for non-MAF usage only
Device Type
MAOFF
– Standard setting used in Australia
Point Type
– R-Correlation Part
UTILITY
– Standard setting
6.3 Addressable Device Settings
Any unused points should be set as utility to avoid potential false alarms from unused fire
point type inputs.
6.3.1
4099-9032 MCP
Device Type
KACPULL
– Standard MCP
Point Type
PULL
– Standard setting
