Simplex 4007ES Panels, Programmer'S Manual

Page: 96 / 168

9-12
4007ES Panel Programmer Manual ( 579-1167)
Custom Control, Continued
Using the
Selective
Signaling Wizard Selective Signaling is typically used to limit the activation of NACs to the area or floor on
which an activated initiating devices is located. In the following example, an activated
initiating device on Floor 2 triggers only the NACs located on Floor 2.
Figure 9-18. Selective Signaling
Selecting
Selective
Signaling Wizard
Tab Start the Selective Signaling Wizard by clicking on the Selective Signaling Wizard tab, which
is located along the bottom left part of the Custom Control window.
Right click in the blank area above the tabs. When the list of options appears, select Create
Group. (See Figure 9-19.)
Figure 9-19. Create Selective Signaling Group
The dialog shown in appears, prompting you for the name of the area/group. Enter a name for
the group in the dialog and click
Next .
.
Figure 9-20. Naming Group