33.6 Communicator with SimpleJack
Page 2
!
If both cellphone and phone lines
are attached, the 33.6 Communicator
with SimpleJack will use the cellphone
and ignore the phone line.
4 Install and start the communications
software.
Refer to the installation sheet that came
with the communications software for
instructions on how to install and start the
communications software. Use the
communications software to send and
receive data and fax.
To use the voice capabilities of the 33.6
Communicator with SimpleJack, your
computer must have a microphone and
speakers or you must use the optional line
access cable with a compatible handset.
Refer to the User Guide for information on
the optional line access cable. Be sure to
configure the communications software
for the appropriate microphone and
speakers.
5 You can remove the 33.6 Communicator
with SimpleJack when done.
It is recommended that you stop the 33.6
Communicator with SimpleJack before
removing the 33.6 Communicator with
SimpleJack. Proceed as follows:
A. Double-click on the PCMCIA icon
located on the right of the task bar;
B. Select the socket in which the 33.6
Communicator with SimpleJack is
plugged;
C. Click on the “Stop” button.
When prompted, push the eject button on
the computer (if applicable) and pull the
33.6 Communicator with SimpleJack from
the socket.
Installation with Windows 95
For installations with Windows 3.x,
Windows NT, OS/2 Warp or MacOS
System 7, refer to the other pages.
1 Start Windows 95.
2 Plug in the 33.6 Communicator with
SimpleJack.
Follow the on-screen prompts. If the “New
Hardware Found” window appears,
perform the following:
A. Insert the “Modem Install Diskette”
provided with the 33.6 Communicator
with SimpleJack into drive A;
B. Select “Driver from disk provided by
hardware manufacturer” and click on
“OK”;
C. Follow the on-screen prompts.
This is a onetime procedure; next time
when the 33.6 Communicator with
SimpleJack is plugged into the socket, the
33.6 Communicator with SimpleJack will be
automatically recognized and configured.
3 Attach the cables.
•
To attach to a phone line.
Lift the hinged top of the SimpleJack
connector and attach a phone line. If there
is no room to open the jack, slide the jack
out and attach the jack to the connector on
the right; then, attach the phone line.
If you find that the SimpleJack connector
is not appropriate for your application,
you may purchase a line access cable (P/N
STI-FAX/CCBL). Call 1-800-4SIMPLE for
ordering information. Refer to the User
Guide for instructions on how to install
the line access cable.
To attach to a cellphone.
Attach the optional cellphone cable to the
connector on the left. Connect the other
end of the cellphone cable to your
cellphone. Refer to the Quick Installation
Guide that came with the cellphone cable
for instructions on how to install the
cellphone driver.
