BATTERY INSTRUCTIONS
BEFORE OPERATING FOR THE FIRST TIME, CHARGE THE BATTERY FOR 4 HOURS
OR UNTIL FULLY CHARGED BUT UNDER NO CIRCUMSTANCES IN EXCESS OF 18
HOURS. Be sure to charge the E-SCOOTER after each use. Keeping the battery
properly charged will help extend the battery life. Do not use the E-SCOOTER while
the power indicator on the instrument panel shows low energy. lf the E-SCOOTER is
over-used the battery's life will be reduced. The E-SCOOTER uses a 48-72V (volt)
battery pack. To charge the battery, connect the 3-pin plug into the charging
receptacle located directly below the front seat. The Battery must be charged while
installing the E-SCOOTER. lf you notice anything unusual about the battery such as a
cracked or leaking battery case, a battery that gets hot while being used or charged,
a battery case that appears "puffy'' or "bloated" etc, or there are any other problems
with the battery, please contact us or your local workshop. The battery is sealed and
is NOT user serviceable. Do not attempt to repair, remove, adjust or in any way alter
any internal or electrical components, controls or wiring without first speaking with a
customer service representative.
The main battery weighs approximately 9 kg. There is no need to remove it from the
E-SCOOTER unless you are replacing it. Use caution on removal. To replace the main
battery pack, lift the seat and unlock the lock located on the right side of the
E-SCOOTER using the ignition key. Proceed to pull the battery out utilizing the handle.
Disconnect the battery cable. The E-SCOOTER is equipped with a 48-72V battery
charger that will interrupt the charging process once the battery has received a
sufficient charge. We hereby strongly suggests that the charger is not used in excess
of 18 hours to prevent any unnecessary wear off on the battery or charger itself.
Charging for periods greater than 18hours may reduce the overall life expectancy and
Efficiency of these items.
1.
!WARNING
DO NOT CHARGE OR STORE THE MOTORING CLOSER THAN 20 FEET
FROM ANY FLAME (E.G. FURNACE, FIREPLACE, WATER HEATER, SPACE HEATER)
2. Be sure to only use 110V AC charger for NA and 220V AC charger for Europe.
3. PLUG the POWER INPUT CORD into the E-SCOOTER charging receptacle located
below the front of the seat or directly on top of the battery. See picture above.
4. Plug the 48-72V battery charger into a 110V or 220V AC power source.
5. The CHARGER INDICATOR LIGHT will illuminate confirming that power is
connected to the charger. lf the light does not come on check all connections. lf it still
does not come on after checking all connections, fuses and that your AC plug is
working, unplug the charger and call your local dealer.
!CAUTION DO NOT DROP THE BATTERY
!CAUTION TO AVOID DAMAGE TO THE BATTERY WHEN CHARGING, USE
ONLY THE CHARGER PROVIDED WITH YOUR E-SCOOTER
9
Summary of Contents for e SCOOTER 1
Page 1: ...MANUAL 2018 SIMPLE e SCOOTER 1...
Page 20: ......
