2. Hold the inside and outer fittings firmly while pulling them away from
one another horizontally.
3. If necessary, loosen the hexagon screw in the inside door handle, but
ensure that you only unscrew a little, so that the screw remains in the
handle.
4. Remove the inside handle from the inside fitting.
Fitted to the door:
IMPORTANT
General instructions: Depending on the handle model, it may not be pos-
sible to remove the inlay immediately In such a case, push the inlay through
the opening in the cover and remove the cover. The inlay remains on the
handle and cannot be removed until the handle is dismounted.
Follow the same steps as for installation but in reverse order.
15.6 Storage mode for Scandinavian Oval DP
SmartHandles are partly assembled when supplied, so that they can be
programmed while still in the packaging. To disassemble, carefully take
hold of the cable at the plugs and pull the two fitting components (outside
and inside fitting) apart.
15.7 Disassembling DoorMonitoring components
The SmartHandle must be fully detached first before the bolt sensor and
fastening screw sensor can be dismounted.
Dismount bolt sensor
1. Disconnect all cables from one another.
2. Conventional fastening system: Carefully press the snap-in adapter to-
gether and pull out through the profile cylinder opening.
3. Rotate bolt sensor 90º to the left, so that the button faces downwards.
4. Pull the bolt sensor out from the profile cylinder in the mortise lock hori-
zontally.
Dismount fastening screw sensor
1. Disconnect all cables from one another.
2. Grip the fastening screw head slit with a small screw driver.
3. Carefully prise out the fastening screw head.
4. Pull out the fastening screw head against the spring force.
SmartHandle
(Manual)
15. Disassembly
126 / 136
