14
15
Assembly Instructions
Engine Operation
4. a
SSembly
i
nStructionS
K
Attach the detergent injection hose (S) to the detergent tank
outlet and then to the the pump detergent inlet (18). Secure
with clams on both sides.
L
R
20
Use a wrench (T) to unscrew the hex screw on the pump unit
(20), and then with your hand screw the pump breather (R) in.
Ö
Now your pressure cleaner is fully assembled and ready to
use.
CAUTION
Do not operate the product before you read and fully
understand next chapter
¢
Engine operation.
5. e
ngine
o
peration
5.1 Adding/Checking Oil
IMPORTANT
Oil has been drained for shipping. Failure to fill engine with oil
before starting engine will result in permanent damage and
will void engine warranty. Add oil according to the instructions.
WARNING
•
Always check the oil level before starting the engine,
making sure the pressure cleaner is on a level surface.
•
Always use oil type -
SAE 10W30
in summer and
SAE 5W30
in winter.
1. Remove oil tank dipstick (22) and wipe it with a clean cloth.
2. Replace and retighten the dipstick (22).
3. Remove the dipstick (22) again and check the oil level. It
should be at the top of the full indicator on the dipstick.
4. If low, add oil slowly into the oil tank. Do not overfill. After
adding oil, wait one minute and then recheck the oil level.
5. Replace and retighten the dipstick (22).
Tip:
when adding oil use provided oil funnel (U).
Ä
22
OIL TANK CAPACITY: 0.6 L
5.2 Adding Fuel
WARNING
•
Make sure there is enough fuel in the fuel tank before
operating the pressure cleaner.
•
Use only clean, fresh and unleaded fuel. Use a minimum
of 87 octane/87 AKI (91 RON).
•
Do not use old gas, and do not mix oil with gasoline.
•
Fuel and its vapours are extremely flammable and
explosive. Fire or explosion can cause severe burns or
death.
1. Stop the engine
(
¢
Stopping Engine)
and let it cool at least 2
minutes before removing the fuel cap (13).
2. Clean the fuel cap area of dirt and debris. Remove the fuel
cap (13) and make sure the fuel filter is in place.
3. Fill the fuel tank (12) with fuel. Do not overfill fuel tank. To
allow for expansion of the fuel, do not fill above the bottom
of the fuel tank neck.
4. Reinstall the fuel cap (13).
†
12
13
FUEL TANK CAPACITY: 3.8 L
IMPORTANT
•
Keep fuel away from sparks, open flames, pilot lights,
heat, and other ignition sources.
•
Check fuel hoses, tank, caps, and fittings frequently for
cracks or leaks. Replace if necessary.
•
If fuel spills, wait until it evaporates before staging
engine.
•
Fill the fuel tank outdoors or in well-ventilated areas.
039-8593-Gas-Pressure-Cleaner-EN-01.indd 14-15
1/11/12 10:21 AM
