Simfer SYD 310 MA DC-R, User Manual

Page: 26 / 66

26
THERMOSTAT SETTING
Temperature settings of your cooler is performed in our factory for
operation in suitable conditions.
Temperature for the preservation of the food is adjusted with the
thermostat by observing it from the thermometer on your cooler (op-
tional).
Internal temperature of your cooler may be adjusted by rotating the
thermostat switch. Position “7” on the thermostat shall decrease the
internal temperature to the minimum level. Internal temperature of
your appliance may be set between -16°C and -24°C.
Putting Food on Your Cooler
You may load the any food you desire as per the examples provided
in this manual in your cooler when the cooler has reached the desired
temperature as empty. (If your product model is equipped with a ther-
mometer, you may control the internal temperature here.
Always consider the maximum load capacity while loading frozen
food in your product. Do not exceed the loading mark on your product.
WARNING:
Operate your appliance three (3) hours without load
before loading your food.
Do not put materials that shall not be cooled in your product.
The basket carriage capacities used in your appliance are specified
below.
DEFROSTING OPERATION
High temperatures and humidity and frequent operation of your
appliance may increase the rate of frost. The more the frost, the
more the operation time. And this causes an increase in the power
consumption. Turn off your appliance and make sure that the frost is
removed in such a case.
You can scrape ice and snow with the ice-scrabble that comes with
your appliance. If the ice layer is too thick to scrape, put the products
in the cooler in a secure place to avoid decaying. Then unplug the
cooler. Leave the windows open for 3-4 hours. Remove the dissolved
ice with scrabble. After it is completely cleaned, put the glasses on
again and plug it. After running for 3 hours, put your frozen products
inside.