Simex STI-638, User Manual

Page: 41 / 52

User manual - RATEMETER STI-638
Register Write Range Register description
Parameters or relay R2 operation
40h
41h Yes
Yes
0 ÷ 999999 “ SEt P ” parameter in “ rELAy2 ” menu, no decimal point included
42h
43h
Yes
Yes
0 ÷ 99999 “ HySt ” parameter in “ rELAy2 ” menu, no decimal point included
44h Yes 0 ÷ 5
“ modE ” parameter in “ rELAy2 ” menu:
0 - “ noACt ” mode; 1 - “ on ” mode; 2 - “ oFF ” mode; 3 - “ in ” mode;
4 - “ out ” mode; 5 - “ modbuS ” mode
45h Yes 0 ÷ 999
“t on”
parameter in
“rELAy2”
menu, expressed in tenth of seconds
or tenth of minutes depend on
“unit”
parameter
46h Yes 0 ÷ 999
“t oFF” parameter in “rELAy2” menu, expressed in tenth of
seconds or tenth of minutes depend on “unit” parameter
47h Yes 0 ÷ 1
“unit” parameter in “rELAy2” menu:
0 - seconds; 1 - minutes
48h Yes 0 ÷ 2
“ALArmS” parameter in “rELAy2” menu:
0 - no changes; 1 - on; 2 - off
49h
4Ah
Yes
Yes
0 ÷ 999999 “ SEt P2 ” parameter in “ rELAy2 ” menu, no decimal point included
Parameters or relay R3 operation
50h
51h Yes
Yes
0 ÷ 999999 “ SEt P ” parameter in “ rELAy3 ” menu, no decimal point included
52h
53h Yes
Yes
0 ÷ 99999 “ HySt ” parameter in “ rELAy3 ” menu, no decimal point included
54h Yes 0 ÷ 5
“ modE ” parameter in “ rELAy3 ” menu:
0 - “ noACt ” mode; 1 - “ on ” mode; 2 - “ oFF ” mode; 3 - “ in ” mode;
4 - “ out ” mode; 5 - “ modbuS ” mode
55h Yes 0 ÷ 999
“t on” parameter in “rELAy3” menu, expressed in tenth of seconds
or tenth of minutes depend on “unit” parameter
56h Yes 0 ÷ 999
“t oFF” parameter in “rELAy3” menu, expressed in tenth of
seconds or tenth of minutes depend on “unit” parameter
57h Yes 0 ÷ 1
“unit”
parameter in
“rELAy3”
menu:
0
- seconds;
1
- minutes
58h Yes 0 ÷ 2
“ALArmS” parameter in “rELAy3” menu:
0 - no changes; 1 - on; 2 - off
59h
5Ah
Yes
Yes
0 ÷ 999999
“ SEt P2 ” parameter in “ rELAy3 ” menu, no decimal point included
Parameters or relay R4 operation
60h
61h Yes
Yes
0 ÷ 999999 “ SEt P ” parameter in “ rELAy4 ” menu, no decimal point included
62h
63h Yes
Yes
0 ÷ 99999
“ HySt ” parameter in “ rELAy4 ” menu, no decimal point included
41