Simex PL 4520, Use And Maintenance Manual

Page: 44 / 60

44
11 Storage instructions
If you are not planning on using the machine for some time, it must be stored in a sheltered area, where it
cannot get knocked or hit.
Position the machine on a pallet (making sure it is stable), then proceed as follows:
- wash it carefully;
- check for and fix any oil leaks;
- check for and replace any damaged parts;
- apply an antioxidant coating (or diesel fuel) to the tools, making sure the liquid seeps in between the
tooth and the tooth holder;
- place a sheet over the machine to protect it from dust;
- cordon off the area where the machine is located to prevent anyone accidentally knocking against its
corners, sharp edges or blunt parts.
12 Recommissioning
Before starting up the machine again after a long period of disuse, the following checks must be carried out:
- grease all the parts subject to lubrication;
- check for and fix any oil leaks;
- check integrity of the hoses;
- check that there are no badly fastened, worn out or missing parts;
- nut and bolt tightness test.
13 Spare parts and accessories
Contact an authorised SIMEX s.r.l. dealer.
14 Disposal
When disposing of the machine or its parts (oils, hoses, plastic parts, etc.), always comply
with the laws in force in the country in which it is located.