Sime B-Essential Round 50, Manual

Page: 37 / 120

37
IT
ES
ENG
RUS
SL
Viewing of screen Description U/M Field
Approved
calibration
Round 25 Round 50
2.7.1 Approved calibration
Sec 0,0 ÷ 60,0 2,0
rpm 0 ÷ 300 110
Sec 0,0 ÷ 60,0 2,8
rpm 0 ÷ 300 120
Sec 0,0 ÷ 60,0 3,7
rpm 0 ÷ 300 130
Sec 0,0 ÷ 60,0 4,6
rpm 0 ÷ 300 140
Sec 0,0 ÷ 60,0 5,5
rpm 0 ÷ 300 150
2,5
160
4,3
185
6,2
210
7,3
225
8,5
240
Viewing of screen Description U/M Field Factory default setting
PAGE - TEST
Resistance Start-up / Shut-
down
Ignition resistance ON/OFF OFF
Air Start-up / Shut-down Activates 24V electrovalve power supply for the compressed air kit ON/OFF OFF
Alarm Start-up / Shut-down Activates the 230V output ON/OFF OFF
Cochlea Shut-down Internal cochlea ON/OFF OFF
Tank shut-down External cochlea ON/OFF OFF
Internal Fan Burner fan rpm 0 ÷ 300
External Fan Cochlea fan rpm 0 ÷ 300
NOTA
This checks that the main components of the burner are working correctly
REMOTE CONTROL
Module
Must be activated to connect the GSM module to connector 6 on the
burner
YES / NO NO
2.7.2 A larm messages
In the event of a fault or malfunction, the following signs appear on the screen:
Description
Failed ignition
Blackout alarm
Faulty water probe alarm
TS overheating
2.7.3 Problems - Possible causes - S olutions
In the table below are reported the most common problems with their possible solutions.
Problem Possible cause Solution
Failed ignition
Empty pellet container Fill the container
Disconnected or broken external cochlea cable
Ignition resistance broken Check the resistance and/or substitute it
Combuston grill is blocked Pull out the grill and clean it
Internal cochlea blocked
Check the internal cochlea and remove any
blockages
Power supply absent Electrical supply to burner not present
Check the mains supply
Check that the electrical cables are connected
correctly
Check that the general switches and the switches
on the burner are in the correct position
Water probe
The probe is incorrectly positioned or connected Check its position and connections
Probe faulty Replace the probe
Pellet container empty Fill the container
Disconnected or broken cochlea cable Re-establish the connection
Cochlea motor not working Check the motor
Power 1 Filling Time from external cochlea to Power 1.
Fan Fan speed at Power 1.
Power 2 Filling Time from external cochlea to Power 2.
Fan Fan speed at Power 2.
Power 3 Filling Time from external cochlea to Power 3.
Fan Fan speed at Power 3.
Power 4 Filling Time from external cochlea to Power 4.
Fan Fan speed at Power 4.
Power 5 Filling Time from external cochlea to Power 5.
Fan Fan speed at Power 5.
NOTA