SIMARINE SCQ25T, User Manual

Page: 12 / 19

E
N
4
.
In
st
al
la
ti
o
n
12
4.
Installation
4.1 Mounting
CAUTION: Install the power unit in a clean and dry place protected from
accidental spilling of liquids.
Remove the shunt cover by unscrewing four screws on top of the cover.
4.2 Cables
CAUTION: Failure to observe the required cable cross-sections can damage
the shunt, wiring, or cause a fire.
SiCOM data cable:
·
For the SiCOM connection use the supplied cable. If not possible, use the
following table to determinate the right cable type.
Cable length Cable type
< 5m No limitations
>= 5m 2x2x0.25 mm2 twisted pair
(recommended)
4.3 Connecting
For proper functionality of Simarine's SCQ25T digital shunt and tank module
it is necessary to:
1. Connect SCQ25T to Simarine PICO via the SICOM port.
2. Connect consumers/generators minus or plus terminal through one
SCQ25T shunt. *
3. Connect any compatible tank or temperature sensors to SCQ25T via the
resistance or voltage input. **
4. Connect the alarm contact to execute specific operation on the alarm.
***
* Each correctly connected shunt needs to be configured. This is done via
PICO in an easy way. The configuration process is
described in PICO’s manual.