Computer Hardware Setup:
Remove the computer from its packaging and place (ideally) to the right of the simulator to
begin wiring setup. Start with wiring the monitor power cables and DVI cables. Special
adapters are required for the triple monitor setup. These are included and the placement is
indicated in the figure below. It is a good idea now to start working on wire management
for the monitors and speakers along the Sim Seats triple monitor mount.
After the monitors are powered and plugged in, place the Logitech sub-woofer to the far
right corner of the setup area and plug in the front channels and into the computer.
Note:
There may be two sound cards with your new computer. The upgraded sound card is usually
the lower card. When in doubt, if it doesn’t work, try the other!
Install the rear speaker
mounts on the seat and run the wires to the sub-woofer.
Run power and USB plugs for the Logitech wheel and pedals. Run the USB plug for the TH8
shifter and button box.
Power up the PC and move on to the software setup process.
