Sim-Lab GT1-EVO, Instruction Manual

Page: 2 / 10

2
| 2 10
BEFORE YOU START:
Thank you for purchasing this Sim-Lab product! On the following pages, you will find detailed instructions on
assembly. This requires only a set of simple tools and some of your time. Please check the bill of materials before
starting (page 9) and make sure all the parts are delivered.
This manual concerns two products, our standalone ‘Servo Motor Holder’ and ‘GT1-EVO Direct Drive Mount’. Since
one is bundled with the other, we combined manuals.
In case you purchased the ‘Servo Motor Holder’ please refer to pages 3, 7(MiGe) or 8(SimuCube) for your assembly
and installation instructions. When installing the servo motors, it is easier if someone can assist you.
Note:
Depending on your date of purchase, you may or may not have received additional washers (A6). If this is the
case, use one on every M8 bolt to install brackets. This was a temporary solution and will be phased out as soon
as possible and therefore is omitted from this instruction manual.
Inserting Slot-Nuts:
You got excited, finished the build, put the caps on, but forgot to install
one element. Do not worry. It happens to everyone. In this diagram, you
can see how to insert a Slot-Nut directly into the slot from the side.
You can also use one of your smaller Hex wrenches to help wiggle
the Slot-Nut in place.
6MM
Tools needed:
13MM