7
SAFETY TIPS
WARNING:
The warnings and
instructions listed and described
hereafter must be followed at all
times. If there is any uncertainty
regarding an intended use of the
HFJ-700A,
contact your
supervisor. Failure to observe these warnings and instructions may
result in injury and/or property damage.
1. Both the
HFJ-700A
jack and the fork lift must be on a firm lever
surface capable of supporting the load. Do not attempt to lift from a
polished or greasy floor.
2. The
HFJ-700A
may be used to lift from either side or end of the fork
lift truck. However, 2 wheels of the lift truck must remain firmly on the
floor.
3. Use extreme caution when lifting narrow fork lift trucks (less than
1016mm Wide) from the sides. Always make sure that the height
between the floor and the bottom of the raised tyre is never more than
one fourth (1/4
th
) of the vehicle’s tread width. See Fig.6.(Tread width
is measured from centre line to centre line of the tyre treads.) If the
one forth figure is exceeded, the fork lift truck could reach the point of
instability and tip over or the angularity of the forklift truck frame could
cause the jack to kick out and drop the load.
Example: If treadwith=914.40mm,then never lift the bottom of the
vehicle tyre more than 228.60mm off the floor.
WARNING
ht
TREAD W IDTH
Fig.6
Summary of Contents for HFJ-700A
Page 14: ...13 ...