Silverline D11042B03, User Manual

Page: 85 / 88

This dishwasher model can be embedded in
modular furniture, under a counter top, a
continuous counter top or a sink.
The housing dimensions must be the same as
those indicated in the figure 1.
The adjustable feet allow the height of the
machine to be varied from 818 to 898 mm.
Installation under the counter top
Apply the steam protection adhesive tape
under the counter top when it is made of
chipboard or of any other non-waterproof
material (fig. 2).
Apply the steam protection adhesive tape on
the dishwasher (fig. 2a)
Insert the dishwasher in the housing "A" then
adjust the height and level it by means of the
adjustable feet (fig. 3-4).
Once the height of the dishwasher has been
defined, it is necessary to fix a 13 mm long
screws "A" in the bottom-frame. This should
only be done on the front feet, as indicated in
the figure 4a .
To allow for easy adjustment of the appliance
when it is fitted into the cavity, some models
are fitted with an adjustable foot located
centrally at the rear. This can be adjusted by
turning a screw located at the bottom of the
front panel of the machine, as illustrated in fig. 4b.
Connect the dishwasher to water and power
following the instruction booklet.
You should secure the dishwasher into the
housing unit. It is possible to do this in the
following ways:
- THROUGH THE ADJOINING HOUSING
UNIT with the supplied 16 mm long screws
"B" (as indicated in the figure 5).
- TO THE WORKTOP (if possible) with
the supplied 30 mm long screws "C" (as
indicated in the figure 5a).
Wooden panel installation
This dishwasher model is equipped with an
auto-balancing system in the door and comes
ready to mount a wooden panel of the
following size:
Width 596,5 mm max
Height from 645 to 720 mm max
Thickness from 18 to 22 mm max
This allows the use of a regular wing taken
from a drawer furniture weighing from 3 to
8 kg; for coverings weighing more, ask for
information to the Assistance Service.
Drilling arrangements
Drill 12 mm deep holes in the panel using a
2 mm diameter drill according to the measures
indicated in the figure 6.
Fasten the two supplied frames with 4 of the
4 x 16 mm diameter screws, setting them at
the center of the eyelets (fig. 7).
Hang the panel on the dishwasher door and
align it by adjusting the frames with the
eyelets.
Fix the frames with the other 6 screws 4x16
mm in the specif holes (fig. 7).
Fasten the panel to the dishwasher door
(fig. 8)
Open the dishwasher door and fasten the
panel with the 4 screws 4x45 mm in the pre-
drilled holes (fig. 9)
Adaptation of the base
For model fitted with fixed pivoting point, in
order to allow the door rotation, a space must
be cut out in the base as indicated in the
figure 1
0.
Proceed as follows:
Open slightly the dishwasher door, let the
covering touch the base and mark its lower
edge on the base with a pencil; cut out the
interfering part.
For models fitted with cantilevered hinges
the rotation requires only a 3 mm space
therefore normally no cut out is required
as shown in fig. 1
0
a.