![background image](http://html1.mh-extra.com/html/silverline/as-5214/as-5214_user-manual_1273373070.webp)
15
flame to burn. Release the switch in few seconds after burning
of the burner, and bring the control switch to the desired flame
position between the maximum and minimum levels. (Figure 2)
If the flame is gone when you release the switch You should
repeat the above process. But this time press the switch and hold
for about 10 seconds.
WARNING;
Do not use burning system more than 15 seconds. If the
burner will not be burned within such time or if the flame will
be cut for any reason whatsoever, repeat burning process
after waiting for 1 minute.
Closing the burners
Turn the control switch right-wise to close the hob.
Flame Failure Device (FFD)
All burners on your hob are equipped with Flame Failure Device
system against flame extinguishing risk (water flow, wind etc.)
When the flame died down while the burner switch is open such
system will provide cutting of the gas supplied to the burner. If
the burning of the burner will be cut due to safety, repeat the
burning operation by switching the burner switch to off position.
Figure 2.