Silvercrest SWKL 2200 A1, Operating Instructions Manual

Page: 12 / 52

GB
│
IE
│
NI
│
CY
│
9 ■
SWKL 2200 A1
Switching the appliance on/off
The appliance will remain in standby mode for about 3 minutes if the mains plug
is plugged into a power socket. The appliance will then switch off automatically.
♦ Press the button for 2 seconds to switch the appliance off. The button
lights and the control lamp goes out.
♦ Press the button again to switch the appliance back on in standby
mode.
Boiling water
♦ Lift the jug off the base to fill it with water.
♦ Open the lid by pressing the release button .
♦ Fill the jug no further than the MAX mark to ensure that no boiling water
can spill out; however, do fill it at least up to the 0.7 L mark. When filling,
hold the jug upright. This allows you to read the scale correctly.
♦ Close the lid by pushing it down until it clicks into place.
♦ Place the filled jug onto the base .
♦ Insert the plug into a mains power socket. You will hear a beep and all buttons
will light up blue briefly. Afterwards, the control lamp and temperature
button
100°C will light up blue.
♦ Press the button to start the heating process. The button will
light up blue during the heating process.
♦ As soon as the water boils, you will hear a beep and the button goes out.
WARNING – RISK OF INJURY!
► Do not open the lid while the water is boiling or extremely hot. There is a
risk of scalding.
NOTE
► You can stop the heating process at any time by pressing the button
or removing the jug from the base .
► If you remove the jug from the base during the heating process, the
heating process will stop and the control lamp flashes blue.
► When you replace the jug on the base , the heating process will not
be continued until you press the
button again.