Silvercrest SWG 500 A1, Operation And Safety Notes

Page: 10 / 27

10
appliance to cool down prop-
erly. This could result in
burn injuries.
Do not operate the appli-
ance with an external
timer switch or any other
remote control system
such as a remote-con-
trolled socket, for example.
Use the appliance only
for its intended purpose.
Check that the supply
voltage required by the
appliance (see rating
plate) matches the voltage
from your power supply.
If the appliance malfunc-
tions, ensure that
appliance servicing work is
carried out only by our
service partners.
Ensure that the mains
socket is easily accessible,
so as to ensure you can
unplug the appliance
quickly if necessary.
OPERATION
• Before use
Unpack the appliance.
Remove the transit packaging.
Check to confirm the appliance has
no visible damage.
• Attaching the handle
Take the carrying handle 3 and slot
it into the mounting bracket from
above. Screw the two screws 5 into
the machined holes in the carrying
handle 3 .
• Setting up the
convection heater
CAUTION!RISK OF BURN
INJURIES FROM HOT
SURFACES! Always keep the
heater at a safe distance from walls,
furnishings and other equipment. To
avoid any risk of fire, this distance
should be at least 50 cm.
Secure the feet 1 by using the
short screws 2 supplied. Work on
a rug or blanket to avoid causing
scratches.
Ensure that the screws 2 have
been correctly attached to the
proper locations on the guard rails
on the sides of the appliance.
• Using the appliance
Note: The appliance and heating
elements have been given a protective
lubricant film: this may produce a
small amount of smoke and odour
on first use. This is entirely normal
and stops after a short while. Please
ensure adequate ventilation when first
using the appliance.
Note: If you have other devices
plugged into the same electrical
circuit, take care not to exceed the
Safety instructions/Operation
277729 Konvektor_content_LB6.indb 10 08.12.17 15:47