SPB 5.000 B1
GB
│
IE
│
NI
│
9
■
♦
During the charging process, the current Power Bank
charge level is shown via the charge level LEDs
(see table in section entitled
Checking the charge level
).
♦
Press the ON/OFF button twice briefly to stop the
charging process and switch off the power bank.
The charge level LEDs go out.
♦
Disconnecting the corresponding plug from the mobile
device.
Troubleshooting
The power bank does not charge.
♦
The connection may be faulty. Check the connection.
A connected device does not charge.
♦
The integrated battery is empty. Charge the battery.
♦
No connection to the device. Check the connection.
♦
Press the ON/OFF button once briefly to start the
charging process.
♦
The charging current of the connected device is too low
(< 50 mA) or too high (> 2.1 A).
♦
The internal overcurrent protection may have been triggered.
Disconnect the attached device and connect the micro USB
charging port to a power source for a short while (see
section
Charging the power bank
).
Afterwards, the power bank can be used again.
NOTE
►
If you cannot solve the problem with the above-mentioned
solutions, please contact the Service Hotline (see section
Service
).
Summary of Contents for SPB 5.000 B1
Page 3: ......
