Silvercrest SMRS 18 A1, User Manual And Service Information

Page: 13 / 66

SilverCrest SMRS 18 A1
English - 11
LED indicators
all LEDs off (while the power switch is
ON) Standby mode (network connection disabled)
orange LED on Idle mode
yellow LED on and blue LED on Speaker is initialising
blue LED flashes slowly AP mode, waiting for network connection
blue LED flashes 3 times fast, followed
by a short pause WPS mode, waiting for WPS signal from router
blue LED on Connected to the network
green LED on AUX mode
green and blue LEDs flashing fast Wi-Fi connection fault
green and blue LEDs flashing slowly two
times Maximum volume has been reached
Getting started
Switching the speaker on
Connect the speaker to the supplied power adapter (B) and then connect the power adapter (B) to
an easily accessible power socket. Toggle the power switch (12) located on the back panel of the
unit to “ON”. The speaker is now in standby mode. The LEDs are off. There is no Wi-Fi connection.
Establishing the Wi-Fi connection
There are 2 ways to connect the speaker (A) to the existing network of your router via Wi-Fi: either
by pressing the WPS / Reset button (7) or by downloading the "UNDOK" control app for free from
the Apple
®
App Store or from the Google
®
Play Store. In both cases, when establishing the
connection for the first time, make sure to place the speaker (A) as close as possible to the router to
achieve an optimum Wi-Fi signal transmission. Then install the speaker (A) within the Wi-Fi signal
range.
Please note that a maximum of 16 devices can be connected to a network.
Establishing the Wi-Fi connection via WPS
If your router features a WPS button, the easiest way to connect the speaker (A) to the network is
using this button.

Place the power switch (12) in "ON" position and briefly press the On/Standby button (1) to
go to connection mode. After a brief initialisation period (yellow and blue LEDs on
simultaneously, then one LED lights green) the blue LED flashes slowly.

Next press the WPS button on your router and confirm the connection by pressing the WPS /
RESET button (7) on the speaker (A) back panel.