9
SMA 550 A1
GB
IE
WARNING - PROPERTY DAMAGE!
Do not clean the appliance or parts of it in the dishwasher!
If you do so, the appliance will be damaged beyond repair.
►
Do not use abrasive or caustic cleaning agents. These can attack the
surface and damage it beyond repair.
NOTICE
►
Ideally, clean the appliance directly after cooling, so that milk residues can
not dry onto it.
For the fi rst coarse cleaning put some water and a little mild detergent into
the carafe (the whisk used
4
/
8
is still fi tted). Thereby, pay heed to the
MIN and MAX
- markings.
Start the appliance so that the whisk ploughs
4
/
8
through the water.
Afterwards, rinse the appliance out with copious clean water.
For a thorough cleaning, proceed as follows:
■
Remove the whisk
4
/
8
from the appliance to clean it and clean the inside
of the appliance with warm water. Add a little detergent. Wipe the interior
with a soft cloth or sponge. Pay special attention to the area around the
drive shaft. Afterwards, rinse the appliance out with copious clean water.
■
Pull the sealing ring
3
off of the lid
1
and clean both parts in mild soapy
water. Remove detergent residues with clean water and dry both parts well.
Push the sealing ring
3
back onto the lid
1
, so that the outwardly facing
sealing lip is located at the bottom of the lid
1
and the inwardly facing seal-
ing lip engages in the groove of the lid
1
.
■
Clean the whisks
4
/
8
in mild soapy water and then rinse them well with
clean water.
■
Clean all exterior surfaces, the plinth
6
and the power cable with a damp
cloth. In all cases, dry the appliance well before using it again. For stubborn
soiling use a mild detergent on the cloth. Ensure that there are no detergent
residues located on and in the appliance before taking it back into service.
Storage
■
Let the appliance cool down completely before putting it into storage.
■
Wrap the power cable around the cable winder
7
under the plinth
6
.
■
Store the appliance at a dry location.
Summary of Contents for SMA 550 A1
Page 3: ......
Page 15: ...12 SMA 550 A1 ...