10 GB/IE/NI
Cleaning and care / Storage / Disposal / Warranty / Service centre
Preparing the product for use / Cleaning and care
Switching on / off / Selecting
the temperature
Insert the mains plug into the mains socket.
Switching on:
Set level 1, 2, 3, 4, 5 or 6 on the control
unit
2
to switch the foot warmer on.
Note:
The function display
3
illuminates
after the foot warmer is switched on.
Note:
This foot warmer features rapid heating,
which allows it to heat up within the first 15
minutes of operation.
Switching off:
Set level 0 on the control unit
2
to switch the
foot warmer off.
Note:
The function display
3
ceases to illu-
minate.
Selecting the temperature:
Just before using the foot warmer, set it to the
highest temperature setting (setting 6). This will
cause the foot warmer to warm up quickly.
The foot warmer can of course be used at any
time if it is switched off. Its teddy plush lining
will warm your feet even if an electric socket is
nowhere near.
When operat-
ing the foot warmer for several hours,
we recommend setting the control
unit to the lowest temperature setting
to prevent overheating of the feet
and subsequent potential skin burns.
Temperature levels
Set the required temperature level on the
control unit
2
.
Level 0:
off
Level 1:
minimum heat
Level 2–5: customised heat
Level 6:
maximum heat
Automatic switch-off
Note:
The foot warmer switches itself off automati-
cally after about 90 minutes. The function display
3
then starts to flash.
Then select the setting 0 and after about
5 seconds, reset the foot warmer to the desired
temperature setting to switch it on again.
Note:
Switch the foot warmer off (setting 0) and pull the
mains plug out of the mains socket if the foot warmer
is not to be used after it has switched off automati-
cally.
Cleaning and care
DANGER TO
LIFE BY ELECTRIC SHOCK!
Al-
ways remove the power plug from
the socket before cleaning the foot warmer.
Otherwise there is a risk of electric shock.
Use a dry, lint-free cloth for control unit
2
cleaning and care.
RISK OF DAMAGE TO THE
PRODUCT OR PROPERTY!
Never immerse the control unit
2
in water or other liquids. It may otherwise be
damaged.
Use a damp cloth and if necessary a little mild
detergent to clean small stains on the foot
warmer.
RISK OF DAMAGE TO THE
PRODUCT OR PROPERTY!
Do
not use chemical cleaning or scour-
ing agents to clean the foot warmer and con-
trol
2
. The foot warmer and control unit
2
may otherwise be damaged.
RISK OF DAMAGE TO THE
PRODUCT OR PROPERTY!
Please note that the foot warmer
must not be washed in a machine, dry-cleaned,
wrung out, tumble-dried, mangled or ironed.
The foot warmer may otherwise be damaged.
Do not wash.
