Silvercrest SFR 3.7 C3, Operating Instructions Manual

Page: 9 / 36

■ 6 │
GB
│
IE
│
NI
│
CY
SFR 3.7 C3
Prior to first use
Assembling the appliance
1) Remove all packaging materials from the
appliance .
2) Push the vacuum attachment
1
onto the motor
unit
7
.
NOTE
► The appliance batteries are not charged on
delivery . Before using the appliance for the
first time, the batteries must be charged for
2 .5 hours .
3) Charge the appliance (see Chapter “Charging
the appliance”) .
The appliance is now ready for use .
Operation
ATTENTION! DAMAGE TO PROPERTY!
► Do not use foaming, corrosive, aggressive,
abrasive or chemical cleaning agents .
These can damage the appliance .
Cleaning
1) Set the tip of the spray nozzle
q
to STREAM
(jet) or SPRAY (fine water mist) .
2) Attach the spray nozzle
q
to the wiping attach-
ment
0
.
3) Place the positioning ring
w
over the tube and
push it onto the wiping attachment
0
so that
it clicks into place . The spray nozzle
q
is now
enclosed by the wiping attachment
0
and the
positioning ring
w
.
4) Fill the spray bottle with water and, if desired,
with a cleaning agent suitable for window
cleaning
e
.
5) Screw the spray nozzle
q
with the fitted
wiping attachment
0
onto the spray bottle
e
.
6) Pull the microfibre attachment
z
over the
retainer on the wiping attachment
0
and
secure it with the velcro fastener .
7) Spray the surface that you wish to clean .
8) Using the microfibre attachment,
z
wipe over
the sprayed areas and loosen any stubborn dirt .
Vacuuming
1) Press the On/Off switch
6
. The control lamp
5
lights up blue .
NOTE
► If the indicator light
5
flashes red during
use, this indicates that the appliance needs
to be charged (see chapter on "Charging the
appliance") .
ATTENTION! DAMAGE TO PROPERTY!
► Move the blade of the vacuum attachment
1
slowly from top to bottom across the wet sur-
faces . Non-compliance can lead to damage
to the appliance .
2) Move the blade of the vacuum attachment
1
slowly from top to bottom across the wet
surfaces . The moisture is removed and sucked
into the dirt container
2
.
NOTE
► Never drag the blade sideways across wet
surfaces . Doing so prevents the water from
being vacuumed up; instead, it runs off the
side of the blade .
3) After you have finished a section, always start
again at the top .
ATTENTION! DAMAGE TO PROPERTY!
► Only continue working until the MAX mark
on the dirt container
2
is reached . Then
switch off the appliance and empty the dirt
container
2
:
Remove the plug
3
on the dirt container
2
.
Pour away the dirty water and reclose the dirt
container
2
. You can then resume working .
NOTE
► If any dirty water remains in the dirt container
2
, you must remove this from the appliance . To
do this, press the release button
9
and remove
the dirt container
2
from the motor unit
7
.
Turn the dirt container
2
so that the nozzle
4
is pointing diagonally upwards . Now pull the
liner carefully out through the nozzle
4
and
shake out the remaining dirty water .