49
GB
4. Items supplied
1 Men's shaver
1 Protective lid
11
1 Plug-in power unit with corresponding ca-
ble
14
1 Cleaning brush
15
1 Storage pouch
16
1 Set of operating instructions
5. Charging
NOTES:
• Charge the batteries for at least 2 hours
before using the device for the first time.
After that, a charging time of 90min-
utes is sufficient.
• In order to increase the service life of
the batteries, we recommend …
… to use the device regularly and with-
out long storage times,
… to discharge the batteries prior to the
charging procedure (LED
20
8
flash-
es red).
• The LEDs of the battery capacity/charg-
ing indicator
8
show the capacity/
charging status of the batteries in per-
cent (
20, 40, ..., 100 FULL
).
• If the batteries are almost discharged,
the LED
20
of the battery capacity indi-
cator flashes red. The device can then
only be used for a short time without be-
ing connected to the electricity supply.
• It takes about 5 minutes to charge the
device sufficiently for one shave.
• When the batteries are fully charged,
the device can be used for approximate-
ly 90 minutes without being connected
to the power supply.
1. Switch off the device with the on/off
switch
6
if necessary.
2. Connect the plug-in power unit
14
to
the socket
9
on the device.
3. Insert the plug-in power unit
14
in into
an easily accessible wall socket, the
voltage of which corresponds to the rat-
ing plate.
4. The LEDs of the charging indicator
8
flashes green, which indicates that the
batteries are being loaded. When the
batteries are fully charged, the LEDs of
the charging indicator light up green.
6. Operation
6.1 Before switching on for
the first time
CAUTION:
after unpacking, there could
still be oil residues on the shaving foils. Re-
move these with an absorbent, lint-free cloth
before using the device for the first time.
6.2 Switching on and off
Irrespective of the batteries’ charging status,
the device can be used at any time in mains
operation.
1. In order to use the power pack, ensure
that the device is switched off.
2. Connect the plug-in power unit
14
to
the socket
9
on the device.
3. Insert the plug-in power unit
14
in into
an easily accessible wall socket, the
voltage of which corresponds to the rat-
ing plate.
4. Remove the protective lid
11
before
switching on.
5. To switch on, press the release button
7
and push the on/off switch
6
upwards.
6. To switch off, push the on/off switch
6
downwards.
__GRA90253_B2.book Seite 49 Mittwoch, 24. April 2013 9:38 09
