SBT 3.6 D2
GB
│
IE
│
NI
│
9
■
Using the appliance
Fitting/removing the attachments
All of the supplied attachments (epilator head
, precision trimmer
, micro shaver
and micro trimmer
) can be fitted and removed in the same manner. Ensure the correct
orientation of the attachment to the hand element
-
:
The curvature of the attachments must always be towards the side of the hand element
-
;
on which the on/off button
3
is located.
♦
To fit an attachment, press it onto the appliance (see Fig. 1)
♦
To remove an attachment, pull it off the appliance (see Fig. 2)
(Fig. 1)
(Fig. 2)
Epilation
When the appliance is charged and the body part to be epilated is prepared:
1) Rub your hand once more against the growth direction of the hairs to be removed.
This will raise the hairs so that they can be better captured by the tweezers.
2) Fit the epilator head
on the hand element
-
. The slight curvature of the epilator
head
must be facing towards the side of the hand element
-
on which the on/
off button
3
is located (see chapter “Fitting/removing the attachments”).
3) Push the on/off switch
3
in the direction of the attachment.
4) Hold the skin tight with one hand.
5) Place the appliance perpendicular to the skin and, without exerting any pressure,
move it
against
the direction of the hair growth. Do not make back and forth or
circular movements. Move the appliance slowly with calm and gentle movements.
Always start anew and pass over the body part to be epilated several times, so that
all of the hair is removed.
NOTE
►
It is possible that some hairs will grow back after a few days. The reason for this
is that these hairs were too short to be removed during the last epilation session.
Summary of Contents for SBT 3.6 D2
Page 3: ...B A C ...
