- 5 -
Hints:
• Cut the ingredients into approx. 3 cm size pieces
before adding them to the bowl
9
.
• The appliance chops the ingredients very fast,
therefore allow the appliance to run only briefly.
• Do not allow the appliance to run for more than
1 minute at a time.
• Should the ingredients get caught up in the bowl
9
or between the blades
z
:
- Switch off the appliance.
- Remove the lid
0
from the mixing bowl
9
.
- Remove the ingredients with a spatula
o
.
7.2 Remove the cutting and grating
blades from the accessory clip
• Remove the blender lid
2
from the blender jug
4
by
turning it clockwise.
• Grasp the accessory clip
3
on the handle at the centre of
the retainer
3
with the thumb
and index finger.
• Pull the accessory clip
3
with the cutting and
grating discs (I-VI) out of the blender jug
4
.
• Remove the cutting and
grating discs (I-VI) from the
holder
3
.
7.3 Insert the cutting and grating discs
back into the accessory clip
• Insert the cutting discs (II/III)
in the retainer slots. Begin
with the inner retainer
slots.The lateral flaps with the
elevation in the middle must
point upwards.
Make sure that all the cutting edges are pointing in-
wards.
• Place the shredder (IV/V),
grater (I) and potato-chips
disc (VI) in the storage slot on
the outside.
• Place the accssory clip
3
back in the blender jug
4
.
Ensure that the rails on the ac-
cessory mounting
3
grip
firmly into the shoulders of the
mixing container
4
.
• Place the cover
2
on the li-
quidiser
4
so that the arrows
on the handle of the liquidiser
4
and on the cover
2
point
towards each other. Turn the
cover
2
anti-clockwise until it
sits firmly.
7.4 Working with the cutting and gra-
ting discs
Caution:
• The cutting edges are very sharp! Exercise inser-
ting and removing or cleaning the discs!
• Never use your fingers, spatula, spoon handles
or similar objects for pushing foodstuff through
the filling shaft
q
!
IB_KH700_38172_LB6 27.10.2009 10:30 Uhr Seite 5