- 4 -
4. When you have finished shaving, slide the
On/Off switch
5
downwards.
5. Clean the appliance as described in the chapter
"Cleaning and Care".
Trimming
The long-hair trimmer
w
integrated onto the Men‘s Sha-
ver is suitable for trimming sideboards and moustaches.
1. Slide the switch for the long-hair trimmer
e
upwards. The long-hair trimmer
w
raises itself.
2. Press the locking switch
4
and, at the same
time, slide the On/Off switch
5
upwards.
The long-hair trimmer
w
is running.
You can now trim the hairs as required.
3. When you have finished trimming, slide the
On/Off switch
5
downwards.
4. Remove any loose hairs on the long-hair trimmer
w
with the brush
9
.
5. Slide the switch for the long-hair trimmer
e
downwards. The long-hair trimmer
w
lowers
itself.
Changing the cutters
Risk of electric shock!
Before changing the cutters
2
ALWAYS disconnect
the mains power plug! Otherwise, there is the great
risk of receiving an electric shock!
If...
- ... the shave is noticeably unsatisfactory,...
- ... you must run the Men‘s Shaver over the same spot
several times to obtain an acceptable result,...
- ... shaving takes noticeably longer,...
- ... damage is visible on the cutters
2
,...
... the cutters
2
must be exchanged.
New cutters can be obtained with the enclosed
order form.
When you have acquired a new set of cutters
2
,
remove the old set of cutters
2
:
1. Press the release button
3
. The cutting unit
2
springs up.
2. Extend the cutting unit
2
a little, so that it allows
itself to be pulled upwards.
3. Replace the new cutting unit
2
back onto the
Men‘s Shaver. Ensure that it engages and sits
firmly.
Cleaning and care
Risk of electric shock!
Always remove the mains power plug before cleaning
the appliance! Otherwise, there is the great risk of re-
ceiving an electric shock!
Attention!
Do not use abrasive, chemical or caustic cleaning
agents to clean this appliance. They could irreparably
damage the appliance.
Cleaning with the brush
Clean the cutting heads
1
with the brush
9
after
every shave.
1. Press the release button
3
, so that the cutting
unit
2
springs up.
2. Carefully tap the cutting unit
2
on a smooth
surface or blow the hair trimmings away.
3. Use the brush to remove the remaining hair
trimmings.
Cleaning under running water
The cutting unit
2
is suitable for cleaning un-
der running water.
1. Press the release button
3
, so that the cutting
unit
2
springs up.
2. Hold the cutting unit
2
under the flow of water
so that the water runs from the inside to the outside,
through the cutting heads
1
.
IB_KH5540_32925_LB6 05.06.2009 12:19 Uhr Seite 4
