SKD 2300 A1
9
3. Press the “Reduce temperature”
button
17
to lower the desired
temperature to a minimum of 5 °C
(41 °F).
Selected specified temperature
20
is
shown in display
5
.
6.3 Setting the heat setting
The appliance has three heat settings:
– 1,000 watts
– 1,300 watts
– 2,300 watts
1. Press button
25
repeatedly until the
desired heat setting is set.
Selected heating level
11
is shown in
display
5
.
2. Press the fan button
15
to switch the fan
on or off.
If the fan is switched on, "Fan"
symbol
12
is shown in display
5
.
Note:
The fan might make a slight
noise, but it does ensure better
circulation of the heated air.
6.4 Setting the heating time
The appliance has a timer for setting the
heating time to between 1 and 15 hours.
The appliance switches off automatically
once the heating time has expired.
1. Press timer button
18
repeatedly until
desired running time
19
is shown in
display
5
.
2. To switch off the timer, press timer
button
18
repeatedly until running
time
19
is no longer displayed.
6.5 Thermal cut-out
For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance
becomes too high, the appliance switches
off automatically:
1. Switch the mains switch
9
to "
0
" to
switch off the appliance.
2. Check whether the air inlet
6
or outlet
4
is obstructed and remove the cause.
If you cannot establish a cause and the
fault occurs repeatedly, have the
appliance repaired or else take it out of
use.
3. Wait for the appliance to cool down.
4. You can then continue to operate it
normally.
6.6 Frost protection
To prevent the temperature in a room falling
below 0 °C (32 °F), proceed as follows:
1. Press the button for selecting heating
level
25
repeatedly until "Frost
protection" symbol
13
appears in
display
5
.
As soon as the temperature in the immediate
vicinity of the appliance drops significantly
below 7 °C (44 °F), the heating
automatically switches on.
As soon as the temperature rises to above
9 °C (48 °F), the heating switches off and
display
5
shows room temperature again.
2. To switch off frost protection, press the
button for selecting heating level
25
repeatedly until "Frost protection"
symbol
13
in display
5
disappears.
RP90866 Konvektor LB3 Seite 9 Dienstag, 9. Juli 2013 12:52 12
