63
3 Operation
GB
CY
IE
3
Operation
3.1
Vacuum cleaning
1.
Attach the desired nozzle
Z
Chapter 2.2, "Assembly"
or
Z
Chapter 2.3, "Using further nozzles (accessories)"
.
2.
Pull out the power cord until the yellow marking is visible
(Fig. 13/1).
3.
Insert the mains plug into a socket with ground/safety
contact.
4.
Switch on the cylinder vacuum cleaner with the on/off
switch (Fig. 14/1). The green indicator light is on.
5.
Set the nozzle switch to "carpet" or "hard floor" accord-
ing to the floor (Fig. 15) to be cleaned:
-
Hard floor (Fig. 15/a)
Parquet, laminate, tiles, PVC, etc.
-
Carpet (Fig. 15/b)
Short- and deep-pile carpets, rugs, etc.
6.
When working with the vacuum cleaner, pull if after you
like a sleigh. .
WARNING:
Danger of injury! A damaged appliance must never be
used. Check the vacuum cleaner and the power cord
each time before using it.
ATTENTION:
Only use the cylinder vacuum cleaner when all filters are
intact, dry and correctly fitted. Make sure that no open-
ings are clogged. Otherwise the vacuum cleaner might
be damaged.
ATTENTION:
Check the requirements of your floorings before using
the vacuum cleaner. Follow the recommendations of the
flooring manufacturers.
WARNING:
Danger of electric shock! If the red marking shows
(Fig. 13/2) retract the cord by pressing the retract button
to pull in the cable (Fig. 14/2) up to the yellow mark
again. Otherwise the cable can break off.
NOTE:
With the bypass vent (Fig. 16) you can quickly reduce
suction power if less suction is needed, e.g. to release
objects accidentally sucked in.
13
14
b
a
15
16
Summary of Contents for 54334
Page 3: ...3 D 1 ...
