■
8
│
GB
│
IE
SAS 7.4 LI C2
■
If the handheld vacuum cleaner is deep-discharged, the charge indicator
lamp
7
flashes alternately red and green (approx. 1 minute). In this case,
switch off the appliance and start charging.
Installation of the wall bracket
DANGER! ELECTRIC SHOCK!
►
Ensure that there are no power cables or other conduits or pipes in the wall
at the location where you intend to bore the holes for the wall bracket
3
.
Drilling into a current-carrying electric cable can be potentially fatal!
1) Place the barrel plug
5
of the mains adapter
4
into the wall bracket
3
as
shown in the following diagram:
–
Open up the small cover (fig. 1).
–
First, feed the cable through the cable routing and then push the barrel
plug
5
into the opening in the wall bracket
3
so that it is firmly in place
(fig. 2).
–
Then close the small cover again.
Fig. 1
Fig. 2
2) Select a suitable installation location for the wall bracket
3
:
It must be possible to remove the handheld vacuum cleaner easily and there
must be an accessible mains power socket for the mains adapter
4
.
3) Drill two holes about 34 mm apart. Use the wall bracket
3
to mark the
holes, to ensure the correct spacing. The drill holes must be suitable for 6 mm
wall plugs.
4) Push the wall plugs into the holes and then screw the wall bracket
3
firmly
into place using the screws.
5) Connect the mains adapter
4
to a mains power socket.
Summary of Contents for 384214 2107
Page 3: ...2 q 0 8 7 6 5 3 9 1 4 ...
Page 33: ... 30 DE AT CH SAS 7 4 LI C2 ...
Page 69: ... 66 NL BE SAS 7 4 LI C2 ...
Page 99: ... 96 PL SAS 7 4 LI C2 ...
