■
14
│
GB
│
IE
│
NI
│
CY
SEMK 105 A1
Troubleshooting
Malfunction Cause
Remedy
The appliance is
not working .
The plug is not inserted into a
mains power socket .
Connect the plug to the power supply .
The appliance is defective .
Contact the Customer Service
department .
The "Add water"
lamp
lights up .
There is not enough water in
the water tank .
Fill the water tank
as described in the
section "Filling the appliance" .
The water filter in the water
tank is blocked .
Remove any deposits or objects that are
blocking the water filter .
If necessary, you can remove the water filter
by pulling it straight upwards . Replace it
before using the appliance again .
To deal with stubborn deposits, proceed as
described in the section "Cleaning and care" .
The pump is defective .
Contact the Customer Service
department .
The "Ice full"
lamp
lights up .
The ice basket is full .
Remove some ice cubes from the ice
basket .
The infra red sensors above
the ice basket are dirty .
Clean the infra red sensors with a soft
cloth .
The infrared sensors above the
ice basket are defective .
Contact the Customer Service
department .
The "Add water"
lamp and
the "Ice full"
lamp
light up .
The ice cube tray in the rear
part of the appliance is
blocked .
Check whether the ice cube tray is
blocked, e .g . by an ice cube, and remove
the blockage .
Pull the plug from the mains socket and
plug it back in again, then restart the
appliance .
No ice cubes
are produced .
The water or ambient
temperature is too high .
♦
Make sure th
at the ambient temperature is
no higher than 32°C .
♦
Make sure th
at the water used is between
8 and 25°C .
The cooling system is leaky .
Contact the Customer Service
department .
The cooling system is
blocked .
Contact the Customer Service
department .
IB_331074_SEMK105A1_LB6-.indb 14
12.11.19 13:55
