21
GB
4. Items supplied
1 hair and beard trimmer
1 power unit
8
2 adjustable comb attachments
1
:
Attachment 1:
1/3/6/9/12/15 mm
Attachment 2:
18/21/24/27/30/
33 mm
1 comb
12
1 scissors
13
1 cleaning brush
14
1 oil
15
1 storage pouch
16
1 set of operating instructions
5. Charging
NOTES:
• Before the device is used for the first
time, and during the following charging
procedures, the device should be
charged for 90 minutes in each case.
• When the batteries are almost empty,
the plug symbol
6
flashes in red. The
device can then only be used for a short
time without being connected to the
electricity supply.
1. Switch off the device with the on/off
switch
4
if necessary.
2. Connect the power unit
8
to the con-
nector
7
of the device.
3. Insert the power unit
8
into a readily
accessible wall socket whose voltage
matches the voltage stated on the rat-
ing plate.
4. The plug symbol
6
is lit red and the
battery is charged. When the battery is
fully charged, the battery symbol
5
flashes in blue. When the battery is ful-
ly charged, the device can be used for
approximately 60 minutes without be-
ing connected to the power supply.
6. Operation
NOTE: Figure D:
For all applications hold
the shaver with an angle of 45° to your skin.
This does not apply to the „Thinning hair“
function, however.
Regardless of the charging state of the bat-
tery, the hair and beard trimmer can always
be mains-operated.
1. Before switching to mains operation,
ensure that the device is switched off.
2. Connect the power unit
8
to the con-
nection
7
of the device.
3.
Insert the power unit
8
into a readily ac-
cessible wall socket whose voltage match-
es the voltage stated on the rating plate.
4. Switch on the device with the on/off
switch
4
.
NOTE:
When the hair and beard trimmer re-
mains connected to the wall socket after being
switched off, it will be charged automatically.
6.1 Pushing on/removing the
comb attachments
WARNING! Risk of injury!
~
Switch off the device before replacing
or changing the comb attachments
1
.
Pushing on
• In order to attach a comb attachment
1
,
push this over the guide rails on the side of
the device onto the comb attachment fas-
tener
9
, until it is heard to click into place.
Removing
1. Push the comb attachment
1
upwards us-
ing a moderate amount of force. The
comb attachment
1
is released from the
comb attachment fastener
9
.
2. Remove the comb attachment
1
.
__325698_1910_Haar und Bartschneider_B8.book Seite 21 Dienstag, 14. Januar 2020 4:42 16
