Silvercrest 279037, Operating Instructions Manual

Page: 15 / 98

SED 3.7 E2
■ 12 │ GB │ IE │ NI
5) Place the epilator perpendicular to the skin and, without exerting
any pressure, move it against the direction of the hair growth.
Thereby, the side with the speed switch must face towards
you. Do not make back and forth or circular movements.
Always start anew and pass over the body part to be epilated
several times, so that all of the hair is removed.
NOTICE
► It may be that the hair grows back after a few days. The
reason for this is that these hairs were too short to be
removed during the last epilation session.
6) When you are finished with the treatment, place the speed switch
to “0”.
7) Clean the epilator head as described in the section “Cleaning
and Care”.
8) Replace the protective cap on the epilator head .
NOTICE
► If the epilator head is damaged, discontinue all further use!
To order a new epilator head , please contact the service de-
partment (see chapter “Guarantee and service”). Please have
the IAN number ready (see operating manual cover).
To replace the epilator head
, please proceed as follows:
― Press the two restraint fixtures together and at the
same time pull the epilator head upwards.
― Press the new epilator head onto the appliance.
Ensure that the gears on the epilator head and on
the appliance mesh with each other. The epilator head
must audibly engage.