Silvercrest 271171, Operating Instructions Manual

Page: 38 / 46

36 GB
WARNING! Risk of material damage
~
Use the original accessories only.
~
Never place the device on hot surfaces
(e.g. hot plates) or near heat sources or
open fire.
~
Never attempt to remove dust or foreign
bodies from inside the device using a
pointed object (e.g. with a tail comb).
~
Do not use any astringent or abrasive
cleaning agents.
~
Do not expose the device to tempera-
tures below -10 °C or above +40 °C.
4. Items supplied
1 hair styler
1 carrier case
1 operating instructions
Before using for the first time
• Remove all packing material.
• Check that the device is undamaged.
5. Power supply
1. Ensure that the switch 2 is in the 0 posi-
tion.
2. Only connect the mains plug 6 to a
properly installed and easily accessible
wall socket whose voltage corre-
sponds to the specifications on the rat-
ing plate. The wall socket must continue
to be easily accessible after the device
is plugged in.
6. Operation
DANGER! Risk of injury
through burning!
~
Do not touch the hot strips at the base
surface of the round brush
1 .
~
Allow the device to cool down com-
pletely before you transport or clean it
or place it in the carrier case.
~
Always make sure that no section of
your hair is curled for too long around
the hot round brush
1 . This may cause
serious damage to the hair or even
cause it to burn.
6.1 Switching on and off
The device has two heating levels. Turn the
on/off switch/temperature controller
2 to:
• 1: Heating level 1 (a blue LED 4
lights up):
lower temperature
• 2: Heating level 2 (two blue LEDs 4
and 3 light up):
higher temperature
• 0: Off
Select one of the two heating levels. Allow
the device to preheat for at least 5 minutes.
B*5$+DDUVW\OHUB%ERRN6HLWH0RQWDJ6HSWHPEHU