44
GB
• Hold the device in such a way that the
comb attachment
1
lies as flat as possi-
ble on the head. Move the device
through your hair smoothly and in only
one direction so as to avoid catching.
• If possible, cut against direction of hair
growth.
• In order to catch all the hair, move the
device several times through each sec-
tion of the hair.
• Comb the hair repeatedly and well.
• In order to achieve a straight cutting line
for cutting lengths over 20 mm, the de-
vice should be passed through the hair
several times from different directions.
6.3 Thinning hair
Use the thinning function to reduce the vol-
ume of the hair without changing its length.
• Push the slider
3
upwards towards the
shaving head
10
. The thinning function
integrated into the shaving head
10
is
extended upwards.
6.4 Cutting hairlines and
beard
WARNING! Risk of injury!
The points of the shaving head are sharp.
Handle with care.
•
Figure A:
adjust the cutting lengths on
the side of the comb attachment
1
, de-
pending on the desired hair length, and
read the cutting lengths on the side of
the comb attachment
1
using the mark-
ing
11
. Now, shorten your beard step-
by-step.
• Use the device only with the shaving
head
10
and without comb attach-
ment
1
, to cut hair very short or to cut
beard and hairline. In this way you can
cut hair lengths of 1-2 mm evenly.
7. Cleaning and care
DANGER! Risk of electric
shock!
~
Pull the power unit
8
out of the wall
socket before you clean the device.
WARNING! Risk of injury!
~
Always switch off the device before
cleaning it.
WARNING! Risk of material dam-
age!
~
The blades
2
of the shaving head
10
may only be cleaned with medical alco-
hol. Do not use any water or other liq-
uids. Oil the blades as described in the
following chapter.
~
Do not use any astringent or abrasive
cleaning agents.
NOTE:
clean and oil the device after every
use.
• Remove the comb attachment
1
. Rinse
the comb attachment
1
with water and
let it dry before reattaching it to the de-
vice.
• Wipe down the housing of the device
with a damp cloth.
Cleaning and oiling the shaving
head
1.
Figure B:
remove the shaving
head
10
from the device by pressing it
with the thumb towards the rear.
2. Remove the hair remnants from the
shaving head
10
by using the cleaning
brush
14
included in the delivery.
3. Clean the blades
2
of the shaving
head
10
with medical alcohol (not sup-
plied). Do not use any water or other
liquids. Let the shaving head
10
dry.
4. Apply a few drops of the supplied
oil
15
to the blades
2
of the shaving
head
10
and spread it out evenly. Us-
ing a soft cloth, wipe off the surplus oil,
if necessary. Only use acid-free oil,
such as e.g. sewing machine oil.
BB*5$B%ERRN6HLWH'RQQHUVWDJ2NWREHU
